III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the electric kettle with the stand. Remove all
possible adhesion foils, stick-on labels or paper from the appliance. Fill the kettle with clean
cold water up to max., turn it on and let the water boil before rst use. Then Pour the water
out and repeat the process several times (at least ve times). You will boil the kettle out
properly this way and get rid of potential taste of plastic. If you feel like you have aftertaste of
plastic from boiled water, we recommend to repeat the procedure according to the instructions
in the paragraph IV. MAINTENANCE – cleaning the kettle. Another recommendation is to
leave the empty kettle open for 24 hours. The material of the kettle coming in touch with water
is approved of sound health properties. Potential slight “smell” or „aftertaste of plastic” during
rst use after unpacking the kettle is a common case and should not be a reason for returning
the appliance. Unwind the necessary length of the power cord B2 from the storage space of
the stand B. Place the stand on a suitable surface, in the height of about 85 cm, out of reach
of children and incapacitated persons (see par. I. SAFETY WARNING) and plug the fork of
the power cord to the electric socket. Hold the kettle A on the handle A4. Open the lid A5 by
pressing the lock button A6. Fill the kettle with drinking water. The minimum and maximum
amount of water is marked on the water gauge (on the picture) A3. Close the lid by snapping.
Put the electric kettle on the stand and turn it to the I position by the A1 button. Function of
the electric kettle is signaled with the control light A2. After boiling the appliance switches off
automatically. Before reaching the boiling point, you can switch off the appliance by turning
the A1 button to the 0 position. Always use fresh drinking water for boiling.
ATTENTION
– When heating water, the lid must be closed, otherwise the steam sensor will not be
working.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to
maximum, water can flow out from the electric kettle in the bottom part of the kettle.
This does not affect safety or other functions and it does not mean any failure of the
electric kettle. In the case of tilting the electric kettle with hot water there is a risk of
scalding. Therefore do not tilt the electric kettle.
– Make sure the sieve and its cover is fit on thorougly in the upper part of the kettle in
order that it does not fall to the bottom!
– If the kettle was removed from the stand during boiling, remains in ON position. This
means that if you put it back on the stand, it will immediately continue in heating.
– Recommendation: When the kettle is not used, do not place it on the stand connected
to the mains. If you are going not to use the kettle for a long time, unplug the power
cord from the wall socket.
IV. MAINTENANCE
Clean the kettle only when it is cooled down! Do not use rough and aggressive
detergents (e.g. sharp objects, scrapers, diluting agents or other solvents)! The
casing of the electric kettle and the heating bottom is made of top-quality stainless steel,
but in common use, impurities from water get stuck on them (water scale), particularly
above the heating element. It is not rust or another material defect of the kettle
container and the appliance is not subject to a complaint for this reason.
Cleaning the kettle
Pour about 50 g citric acid to the kettle with the water scale sediment. Fill the kettle to
about one half and mix. After it dissolves, fill the kettle to 3/4 of the maximum amount of
water. Place the electric kettle on the stand and turn it on. Before boiling, turn off the kettle,
let the solution take effect for about 10 minutes and then pour it out.
GB
15 / 31
To Next Page