To Next PageTo Next Page
Need help?Do you have a question about the eta 955.112 and is the answer not in the manual?
General| Caliber | 955.112 |
|---|---|
| Type | Quartz |
| Display | Analog |
| Functions | Hours, minutes, seconds, date |
| Height | 2.5 mm |
| Diameter | 25.6 mm |
Work must only be performed by properly trained personnel; eye protection is mandatory.
ETA disclaims liability; observe legal provisions for waste handling and hazardous substances.
Explanation of caution and information symbols used in the document.
Parts listed in order for assembling the basic movement.
Guide for applying specific lubricants to watch movement components.
Specifies the minimum torque required for unscrewing components.
Parts listed in order for assembling the handsetting mechanism.
Specific lubrication instructions for the handsetting mechanism.
Parts listed in order for assembling the base and electronic module.
Note on fitting component 4412 based on clearance between movement and case back.
Tests battery voltage and integrated circuit output pulses.
Measures movement operation at reduced voltage and current consumption.
Tests stop lever function and measures motor coil resistance.
Specifications for different hand fitting heights and their corresponding dimensions.
Specifications for hand balance, unbalance, and mass.
