GB - 26
Mounting and removing drive unit (A)
Insert the drive unit by slight pushing into the connecting hole of the respective adapter (Fig. 3) till
the blocking snaps in (you will hear snapping noise). Remove the drive by pushing both locking
buttons A3 and remove the unit by slight pulling.
Mounting and removal of beating adapter (C, C1)
Push beating whisk C slightly to gear C1 to the maximum position (Fig. 4), (you will hear snapping
sound). Remove the beating whisk from the gear in the opposite direction.
Mounting and removal of beating adapter (D, D1)
Push beating whisk shafts D slightly to gear D1 to the maximum position (Fig. 5), (you will hear a
snapping sound). Remove the whisks from the gear in the opposite direction.
Mounting and removal of lid (F3, G3)
Put the lid onto the respective container F or G so that the lugs on its edge snap into the moulded
holes in the container and secure the lid by clockwise movement to the maximum position
(Fig. 6). You can remove the lid from the container in the opposite direction.
Mounting and removal of lid (H3)
Put the lid on multi-purpose container H so that the lugs on its edge snap into the moulded holes in
the container. Bend interlock H2 by slight pushing and turn the lid in the clockwise direction to the
maximum position (Fig. 7). Then release the interlock. Now the lid is secured in the right position.
You can remove the lid from the container in the opposite direction.
Mounting and removal of sickle-shaped knife (F2, G2, H8)
Hold knife at the upper plastic part, remove the protective cover and put it in the container so that
it is inserted on the shaft with its central hole and give it a turn to lock into place (Fig. 8). You can
remove the knife from the container in the opposite direction.
Mounting and removal of graters (H10, H11, H12)
Insert the grater into holder H7 (with the blade up) and secure it by slight pushing (Fig. 9), (you
will hear snapping sound). The grater must be in line with the holder. When taking it out, rst of
all release the grater by pushing on the protrusion from the bottom of the grater and then remove
the grater easily from the holder (Fig. 10).
Mounting and removal of holder (H9)
Hold the holder (with installed grater) at the upper plastic part and put it in the respective container
so that it is inserted on the shaft with its central hole (Fig. 11). You can remove the holder from the
container in the opposite direction.
IV. USING ACCESSORIES
Please consider the following tips for preparing food as examples and inspiration, the purpose of
which is not to provide instructions, but to show various possibilities of preparing food.
Blending adapter (B)
Be careful, knife blades are very sharp! The blender is intended for mixing liquids, juices, milk
shakes, milk, sauces, soups, mayonnaise, children‘s and dietary food, for making purée, etc.
Hold hand blender A with your hand and put blending adapter B into container E lled with food.
Hold the drive unit and the container rmly. Start the drive unit by pushing switch A1. When working,
move the blender in the container to process the food thoroughly. Food will be processed in about
10 seconds to 2 minute. After nishing work, release the switch, remove the blending adapter from
the container and clean it.
To Next Page
Loading...