Temperature maintenance feature
When in stand-by mode, press and hold A2 for a while to show the “KEEP WARM”
message on the top of the display. Then continue by setting the required temperature.
After preset temperature has been reached, sound signal will be given and the maintaining
temperature function will be activated automatically. This function will remain active for
approx. 2 hours, then the device will be switched off automatically. This function can also
be deactivated by pressing A1.
Memory
If in operation (i.e. heating or KEEP WARM functions are on) and removed from the
base plate, preset function of the device will be stored. As soon as you place the kettle
on the base plate again and press A1, this function will continue. Press A1 if you want to
deactivate the memory.
Notes
– If the kettle is not on the base plate, the electronic operation system is not active.
– If the heating temperature is lower than current water temperature in the kettle, the kettle
will be switched on and waiting until the temperature drops to the set value (sound signal
will be given). Then the KEEP WARM function will be activated automatically.
– If you are preparing food for very young children (e.g. to 40 or 70 °C), the water must
be heated to a boil (100 °C) first.
– When heating water, the lid must be closed, otherwise the kettle will not turn OFF.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up to
maximum, water can flow out from the electric kettle in the bottom part of the kettle.
This does not affect safety or other functions and it does not mean any failure of the
electric kettle. In the case of tilting the electric kettle with hot water there is a risk of
scalding. Therefore do not tilt the electric kettle.
– During heating, current temperature will be displayed until the set temperature value
is reached. Then preset temperature will be displayed. If A2 is pressed, current
temperature will be displayed again. The temperature sensor is located at the bottom of
the kettle, consequently, the temperature will be displayed with a small tolerance, due
to temperature difference in the bottom and upper part of the kettle.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord
out of the socket! Clean the kettle only when it is cooled down! Do not use rough
and aggressive detergents (e.g. sharp objects, scrapers, diluting agents or other
solvents)! The housing of the kettle is made of high-quality plastic, the heating bottom
and inner surface of the kettle are made of high-quality stainless steel, however, a slight
sediment (scale) during standard use /particularly, above the heating element/ cannot
be avoided. It is not rust or another material defect of the kettle container and the
appliance is not subject to a complaint for this reason.
Cleaning the kettle
Pour about 50 g citric acid to the kettle with the water scale sediment. Fill the kettle
to about one half and mix. After it dissolves, fill the kettle to 3/4 of the maximum amount
of water. Place the electric kettle on the stand and turn it on. Before boiling, turn off the
kettle, let the solution take effect for about 10 minutes and then pour it out. Clean the
kettle thoroughly with clean water. Repeat the whole procedure if the kettle is too soiled.
Clean the electric kettle regularly!
GB
17 / 34
To Next Page
Loading...
