Why is the air not properly sucked out by my eta ETA176290000?
If the air is not being properly sucked out by your eta Food Saver, it could be due to several reasons. The foil might have a hole in it, or you might be using a plastic bag instead of the foils supplied by the manufacturer. Ensure you are using the correct type of foil. Also, make sure that you insert the whole open part of the bag into the sucking area.
How to fix a weld on the foil that is not tight on my eta Food Saver?
A loose weld on the foil of your eta Food Saver can occur for several reasons. First, smooth out any creases in the seal and repeat the welding process. Ensure you keep a 30-second break between individual welds. Remove any food leftovers or moisture from the weld area and dry the foil. Wait until the control light turns off, indicating the weld is complete. When pressing the lid, use both hands to ensure it is tight.
What to do if my eta Food Saver welder does not suck air?
If your eta Food Saver welder is not sucking air, check that the bag is correctly placed in the sucking area. Ensure the bag is not stuck together before the nozzle; if it is, lift the bag slightly and stretch it. Also, verify that the sucking nozzle of the exhauster is not clogged and clean it if necessary.
Why is the weld melted too much on my eta Food Saver?
If the weld on your eta Food Saver is melting too much, it could be because the welding part is too hot. Leave the welder open to cool down for a few minutes. Also, ensure you are using foils supplied by the manufacturer and not a plastic bag.
General| Brand | eta |
|---|---|
| Model | ETA176290000 |
| Category | Food Saver |
| Language | English |
To Next Page