After each frying
– We recommend filtering or straining lukewarm frying oil, pouring it in a suitable container,
closing the container and putting it in a fridge – thus you will prevent creation of
undesirable substances.
ATTENTION
Hot frying oil melts down a plastic bottle and there is a risk of injury!
Removal of unpleasant smell
Some food (e. g. fish) can leave unpleasant smell in the frying oil. You can neutralize the
smell in the following way:
– Heat the frying oil to the temperature of 160 °C.
– Put several parsley sprouts or two bread slices in the frying oil,
– Wait till “bubbles” disappear, then take out the parsley or bread using a suitable tool. The
frying oil will now have neutral taste.
Filtration or replacement of oil
It is not necessary to replace the oil after every use. If you fry mainly potatoes and filter the
oil, it is possible to reuse it 8-10x. Do not use the same oil longer than 6 months.
To carry out the filtration or replacement proceed as follows:
– disconnect the deep fryer from the electricity grid
– pour the fully cooled oil out of the pot B into another container with a suitable volume
capacity
– wash and thoroughly dry the pot B
– pour the oil back through an appropriate filtration paper
IV. MAINTENANCE
Before carrying out any maintenance disconnect the appliance from the power grid
by pulling out the plug on the power cord from the el. socket and allow it to cool
down! After each use wipe the outer surfaces with a soft damp cloth. Do not use abrasive
and aggressive cleaning agents and metal tools, which could scratch the surface during
cleaning. Every time the medium is poured out remove any remains of fat or remains from
previous frying that have stuck to the heating element D1. Wash all other parts (cover,
pot, basket, handle, lid) in hot water with dish-washing detergent, and then rinse out with
clean water and allow it to fully dry (you may use a dishwasher). Never dry plastic moulded
parts above a heat source (e.g. fire stoves, electric/gas stoves, etc.). It is normal for the
colour of the surface to change over time. This change in no way changes the properties of
the surface and is not a reason for complaint about the appliance! Wipe the power cord D7
with a cloth. Store the appliance thoroughly cleaned in a dry, dust-free location that is out of
reach of children and incapacitated persons.
Removing the filters (E3)
Pull gently to remove the cover from the lid E. Remove the filter E3 from the lid. Wash the
filter in lukewarm water with standard detergent and allow it to dry thoroughly. When dry,
place back into the lid. Insert the lugs on the cover into the openings in the lid and click the
cover shut.
22
GB
/ 35
To Next Page
Loading...