– Do not dispose the battery into fire. There is a risk of explosion!
– Do not charge a battery which is leaking electrolyte.
–
Do not expose the battery to temperatures higher than 50 °C to prevent damaging the battery.
– Do not put the trimmer on hot heat sources (e. g. oven, stove, radiator, etc.)
– Also, do not put the trimmer in the on position on soft surfaces (e. g. bed, towels, sheets, carpet);
the surfaces or the appliance could get damaged.
– The power cord of the adapter must not be damaged with sharp or hot objects, open fire and it
must not be sunk into water.
– The adaptor supplied with this appliance is intended for this appliance only, do not use it for other
purposes. Also, use only the supplied adaptor with this appliance, do not use any other adaptor for
charging (e.g. from another appliance).
– Never use the appliance for any other purpose than for the intended purpose described in these
instructions for use!
–
During normal operation, the accumulator batteries are not taken out. Take out the batteries only if the
appliance is to be disposed (see par. V. ENVIRONMENTAL PROTECTION).
– The producer is not responsible for any loss caused by improper handling of the appliance and its
accessories (e. g. injury, appliance damage, fire, etc.) and its guarantee for the appliance does not
apply in the case of non-compliance with the safety instructions above.
II. DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (fig. 1)
A – trimmer
A1 – on/off button + change speed
A2 – blade burden indicator (BURDEN)
A3 – cutting speed (K. RPM.)
A4 – leftover battery indicator
A5 – oil indicator
A6 – charge / battery indicator
A7 – blade cut length switch (0,8 / 1,2 / 1,6 / 2,0 mm)
A8 – cutting head
A9 – blade
B – attachments
B1 – Thin-out
B2 – comb attachment (3 mm)
B3 – comb attachment (6 mm)
B4 – comb attachment (9 mm)
B5 – comb attachment (12 mm
B6 – comb attachment (15 mm)
B7 – comb attachment (18 mm)
C – charging adapter
D – charging stand
E – brush
F – blade lubrication oil
G – travel case
III. INSTRUCTIONS FOR USE
Before you can use the appliance, its batteries must be charged. The operation time for one charge
depends on the attachment used and workload. Attachment is around 240 minutes.
To Charge/Recharge
–
Fully charge Clipper before using for the first time or after non- use for a long period of time.
– Charging or recharging at temperatures below 10°C or higher than 40°C adversely affects lifespan
of the battery.
– Continuously recharging Clipper will reduce lifespan of battery.
20
GB
/ 46
To Next Page
Loading...
Need help?
General
