– Do not use USB ports on other devices (e.g. computers, laptops, tablets, mobile phones, etc.) to
power the appliance. Such devices may not be dimensioned for the current consumption of the
appliance and it could damage them.
1) Be certain Clipper is OFF.
2) Select charging method (directly through the adapter or with the use of the charging stand), see
fig. 2. Then connect the adapter to power.
3) Charging is in progress when the A6 charging indicator switches on and the battery life is
changing. When fully charged, the displayed values become steady, the A6 indicator switches off
and the average battery life in minutes, which corresponds with the cutting speed, remains visible
(AVL TIME MIN).
4)
It will take approximately 3 hours to fully charge the Clipper. Do not exceed the set time of charging!
5) After charging, unplug the adaptor from the mains rst and only then unplug the connector from
the appliance.
Optimize the working life of the battery
– Do not charge for more than 3 hours.
– Do not keep cord permanently plugged in.
Use
The trimmer can be used without the adapter (for cutting contours) or with the selected adapter
B1–B7 according to the required cut length.
Note
When removing the attachment (B1–B7), release the lock with your fingers (see Fig. 4C, D).
Controls
Turn on the trimmer – if it is off, shortly press the A1 button.
Change the trimming speed – shortly press the A1 button when in operation.
Turn off the trimmer – press and hold the A1 button.
There are 5 different cutting speed settings in thousand revolutions per minute (K RPM) indicated
on the trimmer display. Blade overburden indicator A2, showing the current burden of the trimmer,
is also available.
Hair clipping
– We recommed oiling the blades with the oil F attached before first use.
– Before you start clipping, make sure that the head of the person whose hair you are cutting is at the
same level as your chest so that all parts of his/ her head are clearly visible and within easy reach.
– Only use the clipper on dry hair.
– Do not use on freshly washed hair.
– Before you begin, comb the hair in the direction of growth.
– To achieve optimal clipping results, always move the clipper slowly through the hair against the
direction of hair growth.
– In case an blade A9 gets blocked, the appliance must be turned off immediately and the cause
of the block removed.
Note
You may also use the blade cut length switch A5 for finer cut setting.
21 / 46
GB
To Next Page
Loading...
Need help?
General
