II. DESCRIPTION OF THE APPLIANCE
A – hair straightener
A1 – I/O button A5 – Iron´s end
A2 – temperature regulator A6 – turning joint of power cord
A3 – control light A7 – power cord
A4 – heating plates A8 – slider control of jaw lock
III. INSTRUCTIONS FOR USE
Remove all the packing material and take out the hair straightener. Put the hair
straightener on suitable even surface (see par. I. SAFETYWARNING). Plug power cord
connector A7 to an electric socket. Set regulator A2 to the required temperature (120,
135, 150, 160, 170, 185 or 200 °C) according to the type of hair. Switch on the hair
straightener by pressing A1 button (about 2 sec). Control light A3 will flash red, which
signals heating of the plates. As soon as the set temperature is set, control light A3 will
turn red permanently. Then the temperature will be kept automatically. Switch off the
appliance after use by pushing A1 button (about 2 sec), (control light A3 will go out) and let
it cool down before putting.
Note
– You can change temperature by regulator A2 during hair styling. If you set higher
temperature, wait till the control light will go on. If you set lower temperature, wait for
a couple of minutes before the temperature drops. Then you can continue hair styling.
– Turn the regulator only in the range of level 120 to 200
o
C. If you turn the button too
much using force, you can damage the regulation system.
To Next Page
Loading...
Need help?
General