EasyManua.ls Logo

Etac Molift Air 200 Quick Guide

Etac Molift Air 200
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Molift Air 200 / 350
Quick guide
1
2
3
7
8
6
5
4
1. Trolley
2. Hoist
3. Side covers
4. Emergency stop/ Emergency
lowering
5. Lifting belt
6. Quick release pin
7. Hand control
8. Sling bar
Hoist components:
Only certified personnel are allowed
to open hoist or accessories to perform
service or repair.
Read User Manual before use! This Quick
guide does not replace User Manual. It is
important to fully understand the content
of the user manual before attempting to
use the equipment.
Lift and transfer of a client will always pose a certain
risk and only trained personnel are allowed to use the
equipment and accessories covered by this user manual.
The rail system must be installed by certified personnel in
accordance with applicable installation instructions. The
lifter is not intended to be operated by the client being
lifted.
The Hand control has 2 buttons
for lifting and lowering, or 4
buttons if the hoist is equipped
with propulsion. The Hand control
has an indicator light that will illu-
minate when battery level is low
and the lifter requires charging
Wrench symbol / Service
indicator
Battery symbol / Battery
indicator
Charger indicator Mode
Green flash Not connected to hoist
Yellow Charging
Yellowash Top of charge
Green Fully charged
General information:
Battery / Charger indicator:
QG16601 Rev. A 2020-10-29

Other manuals for Etac Molift Air 200

Question and Answer IconNeed help?

Do you have a question about the Etac Molift Air 200 and is the answer not in the manual?

Etac Molift Air 200 Specifications

General IconGeneral
Lifting Capacity200 kg
Safe Working Load200 kg
Power SourceBattery
Emergency StopYes
Emergency LoweringYes
Warranty2 years
MaterialAluminum
Lifting Speed30 mm/s

Related product manuals