Need help?Do you have a question about the ETAS BR XETK-S3.0 and is the answer not in the manual?
General| Host Interface | Ethernet |
|---|---|
| Protocol Support | XCP on Ethernet |
| Operating Temperature | -40°C to +85°C |
| Sampling Rate | Up to 1 MHz |
| Memory | 256 MB |
Defines the product's intended applications and limitations for safe operation.
Explains the meaning of DANGER, WARNING, and CAUTION safety messages.
Covers assembly, operation, and electrical safety measures to prevent damage or injury.
Explains product symbols and identification labels for conformity.
Describes the product's use as an emulator probe for Infineon AURIX microcontrollers.
Details measurement interface, calibration, ECU flashing, and Ethernet capabilities.
Provides a block diagram and explanation of the BR_XETK-S3.0's internal structure.
Details the connection, pin definition, and function of the ECU interface connector.
Explains the Automotive Ethernet interface and its connection requirements.
Describes the power supply requirements and connection for the BR_XETK-S3.0.
Explains the meaning of the Red, Green, and Yellow status LEDs.
Details the Device Access Port (DAP) interface and its operation modes.
Explains how the product handles data emulation and measurement.
Details trace measurement and explains the product's trigger modes.
Covers reset mechanisms and the CalWakeUp function for ECU control.
Provides instructions for physically attaching the device to the ECU housing.
Details how to connect the BR_XETK-S3.0 to the ECU using adapter cables.
Explains how to wire the device for computer connection, including media converters.
Introduces project-specific adjustments and the XCT Tool for configuration.
Details hardware configuration parameters and their possible values using the XCT Tool.
Lists compatible hardware and PC requirements for using the device.
Specifies software versions required for measurement, calibration, and flashing.
Describes the ED RAM used for data emulation and its standby power status.
Provides details on connection, protocol, IP address, and cable length.
Details voltage, current, and power dissipation parameters for power supply.
Details timing parameters for the 2-pin and 3-pin DAP modes.
Provides pin assignments for the Automotive Ethernet and ECU interface connectors.
Emphasizes using certified cables and adhering to maximum lengths for reliable operation.
Details ETABR and CBAM cables for Automotive Ethernet interface connections.
Details CBEB cables for Ethernet connections and splitter functions.
Details ETAM ECU adapters for connecting to different ECU interfaces.
Details the waterproof case for mounting the BR_XETK-S3.0.
Lists order information and package contents for BR_XETK-S3.0A and S3.0C models.
Lists various cables, adapters, and media converters for product use.
Provides contact details for technical support and local sales offices.
To Next Page
