Setpoint Menu - eSelect M
From main screen select OK to display the screen shown
to the right. Use the arrow button to select the channel
you wish to set the setpoint for.
Press OK button to change the default setting and after
changing press using left / right arrows press OK to
confirm.
Using the left / right arrows for the setup of Working
Mode, acid or alkaline, Mode, on/off or timed pulses, Hysteresis
value, Setpoint delay, Measuring parameter, Alarm min / max
settings, Overdose timing, Max dosing timing, Startup delay, and
Priming on/off.
Above applies to expert mode only.
To Next Page
Loading...
Need help?
General
