This guide covers all models of MOS-IR and MOS-DT ceiling occupancy sensor.
The MOS-IR product family includes:
MOS-IR-xA Motion sensor with small motion short range lens (1000 sq. ft.)
MOS-IR-xB Motion sensor with large motion large range lens (1900 sq. ft.)
MOS-IR-xC Motion sensor with high bay lens (6300 sq. ft.)
The MOS-DT product family includes:
MOS-DT-xA Motion and audio sensor with small motion short range lens (1000
sq. ft.)
MOS-DT-xB Motion and audio sensor with large motion large range lens (1900
sq. ft.)
Where x is the frequency of the unit: U=902 MHz, Y=868 MHz and J=928 MHz.
The package includes the occupancy sensor, lens mask sticker, mounting
plate with integrated magnets for T-Bar ceiling, wire straps and installation
guide.
These Occupancy Sensors are intended for indoor use only in a dry location.
MOS-IR/DT
WIReleSS CeIlIng MOunT SenSOR
fOR OCCupanCy / VaCanCy DeTeCTIOn
INSTALLATION GUIDE
Note:
The MOS is a solar powered device that absorbs solar energy
storing it for use during low light periods. Before assigning
the MOS device to a receiver/controller, the device should be
exposed to a good light source for a minimum of 5 minutes
or install the start assist battery.
i
To Next Page
Need help?
General
