EasyManua.ls Logo

ETC ERn-NET User Manual

ETC ERn-NET
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ETC Setup Guide
ERn Ethernet Switch Module Installation
Corporate Headquarters
Middleton, WI, USA
Tel +608 831 4116
Service: (Americas) service@etcconnect.com
London, UK
Tel +44 (0)20 8896 1000
Service: (UK)
service@etceurope.com
Rome, IT
Tel +39 (06) 32 111 683
Service: (UK) service@etceurope.com
Holzkirchen, DE
Tel +49 (80 24) 47 00-0
Service: (DE) techserv-hoki@etcconnect.com
Hong Kong
Tel +852 2799 1220
Service: (Asia) service@etcasia.com
Web: etcconnect.com
© 2016 Electronic Theatre Controls, Inc.
Product information and specifications subject to change. ETC intends this document to be provided in its entirety.
7180M2230
Rev B
Released 11/2016
The ERn Ethernet Switch module installs in the bottom option module tray of the ERn enclosure, replacing
the blank module that ships in the ERn from the factory. The bottom option slot is the only position for the
Ethernet switch module.
The ERn Ethernet switch (ERn-NET) provides four ports of Power over Ethernet (PoE). The ERn Ethernet
switch kit includes an option module, Ethernet patch panel, Ethernet switch panel, and B Ethernet patch
cables.
The Ethernet patch panel includes four punch down terminal blocks that accept CAT5e wire. Building wire
enters the ERn enclosure and terminates to this patch panel. For each Ethernet data run, an Ethernet patch
cable is provided to connect between the Ethernet patch panel and the Ethernet switch panel.
Install the Ethernet Switch Option
1: Install the Ethernet patch panel to the mounting studs on the rear panel of the ERn enclosure using
the hardware provided.
2: Install the Ethernet switch panel to the mounting studs on the bottom panel of the ERn enclosure
using the hardware provided. Be sure to install the panel with the card edge receptacle facing the
front of the ERn enclosure.
Note:
The Ethernet switch module (ERn-NET) is not designed for use in a rack mounted ERn
unit. Instead, utilize a rack mounted Ethernet switch (provided by others).
Additionally, the ERn-NET is not supported in an ERn4 enclosure at 230 VAC.
Option
module
Ethernet patch
panel
Ethernet switch
panel
Step 1:
Step 2:
Question and Answer IconNeed help?

Do you have a question about the ETC ERn-NET and is the answer not in the manual?

ETC ERn-NET Specifications

General IconGeneral
BrandETC
ModelERn-NET
CategorySwitch
LanguageEnglish

Summary

Install the Ethernet Switch Option

Install Ethernet Patch Panel

Install the Ethernet patch panel to the mounting studs on the rear panel of the ERn enclosure using the hardware provided.

Install Ethernet Switch Panel

Install the Ethernet switch panel to the bottom panel of the ERn enclosure, ensuring the receptacle faces the front.

Connect CAT5e Wiring

Prepare and Terminate CAT5e Wire

Pull CAT5e wire, remove connector from patch panel, and terminate using a 110 punch down tool per color code.

Connect Ethernet Patch Cables

Connect patch cables from the patch panel punch down connector to the Ethernet switch panel RJ-45 inputs.

Status Indicators

Related product manuals