10
However, if your watch should stop, simply turn the
crown 6 through a few turns clockwise to restart it.
When fully wound, your watch has a power reserve of
approximately 60 hours.
NOTE
There is no end of winding stop. A protective mecha-
nism prevents excessive winding of the movement.
2.3 SETTING THE TIME
CROWN 6 PULLED OUT TO POSITION C :
LOCAL TIME
CROWN 6 PULLED OUT TO POSITION B :
2
ND
TIME ZONE HOUR
Local time: pull the crown 6 out two notches to position
C. The small seconds hand 3 will stop. Then turn it in
either direction to position the hands 1 and 2 to the desi-
red local time. When the hour hand passes the 12 o'clock
position, you will see whether it is indicating midnight
(the date changes) or midday (the date does not change).
Check that the date set previously has not changed.
2nd time zone time: pull the crown 6 out to the interme-
diate position B. Then turn it clockwise to position the 4
2nd time zone hour hand to the desired reference time.
Then push the crown 6 back in against the case to the
rest position A. The small seconds hand 3 will restart.
ENGLISH
10
To Next Page
Loading...
