Need help?Do you have a question about the ETI 3000 Series and is the answer not in the manual?
Operate dry-wells in ambient temperature 10-30 °C and humidity 5-95% (non-condensing). Ensure vents are clear.
Power lead is clamped through rear panel, not removable. Plug into grounded AC outlet.
Power switch located on rear panel. Operation indicated with 1 and 0.
Internal fan runs continuously for cooling. Maintain 150mm space from vents.
Stand folds flat or swings out for inclined position. Not a carrying handle.
Aluminium dry-well on front panel with holes for probes. Details probe sizes for models 3001-3004.
Numeric LED display shows actual temp. Control Output Indicator shows heater state. Set point adjusted via arrow buttons.
Place unit on flat surface, 150mm space. Swing stand, plug in, switch on. Fan starts, display illuminates.
Set temp 33-300 °C in 0.1 °C increments. Control indicator shows heater active. Allow warm-up for stability.
Insert probe into dry-well hole. Ensure snug fit for heat transfer. Compare readings for accuracy.
Requires little maintenance. Clean case with damp cloth. Remove foreign objects from dry-well holes.
Two-year guarantee against defects. Excludes damage from misuse or wear. Details at etiltd.com/terms.
General| Engine Type | 4-Stroke OHV |
|---|---|
| Fuel Type | Gasoline |
| Fuel Tank Capacity | 4 gallons |
| Power Output | 120V |
| Noise Level | 68 dB |
| Starting Method | Recoil |
| Outlet Types | 2 x 120V 20A Outlets |
To Next Page
