ROTATIONAL DISPLAY - The display will rotate 180° depending on the direction
the instrument is pointing so that it can be used in either hand.
DISPLAY SLEEP INTERVAL – the display will ‘SLEEP’ after a settable time (default
30 seconds), when no movement has been detected. The instrument will remain
connected whilst in display sleep and will wake up when movement is detected.
INTELLIGENT BACKLIGHT - features a light sensor
which will automatically turn the backlight on in
low light conditions. The backlight will remain on
for 10 seconds and automatically turn off if no
movement is detected.
AUTO-OFF - If the instrument is not connected to
Bluetooth within the set auto-off interval, it will shut down.
The timer is reset with any movement or button press.
STORAGE & CLEANING – Clean the instrument regularly
with an anti-bacterial probe wipe to avoid potential
food-borne bacteria growth. The thermometer should
be stored between -20 to 60 °C. WARNING: IPA and
other solvents may cause damage to the case and
screen of this instrument.
BATTERY REPLACEMENT - A battery symbol
‘ ’ indicates that the batteries will need replacing.
The instrument continues to measure accurately
but we recommend that the batteries be changed
as soon as possible.
To replace the battery, loosen the battery cover
screw using a Pozi (PZ1) screwdriver to remove
the battery cover. Replace with a single AAA battery
noting the polarity. Tighten the battery cover screw
until the battery cover is snug onto the seal.
Do not over-tighten.
AMBIENT- The ambient operating range is -20 to 50 °C.
LCD ERROR MESSAGES - If the ambient temperature falls outside the operational
range, then either ‘Amb-Lo’ or ‘Amb-Hi’ will be displayed. This will continue until
the ambient temperature has returned within the limits. The thermometer should
be allowed plenty of time (minimum 30 minutes) to stabilise to the working/
room temperature. ‘Hi-Err’ or ‘Lo-Err’ will be displayed when the temperature
being measured is outside of the instrument’s measurement range. ‘Error’ will be
displayed if the instrument has developed a fault.
.
To Next Page
Loading...