EasyManua.ls Logo

ETNA AP290RVS - Removing the Grease Filters; Replacing the Carbon Filter; Lighting

ETNA AP290RVS
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 8
Grease filters
Removing the grease filter
Switch off the electricity! Remove the plug from the socket or switch
the electricity off at the mains. Pull the grease filter towards you and tilt
it downwards at the front.
Carbon filter
Replacing the carbon filter
The carbon filter must always be used if the cooker hood is not ducted.
• Remove the grease filter.
• Attach the carbon filters to the motor.
• Replace the grease filter.
Note!
• Saturation of the activated charcoal will eventually occur after
prolonged use, depending on the type of cooking and how
frequently the grease filter is cleaned.
• The carbon filter needs to be replaced at least every four months.
• The carbon filter cannot be washed for reuse. Saturated carbon is
not environmentally friendly. Change the filter regularly.
Lighting
Please note! Disconnect the appliance from the mains by removing
the plug from the socket before the changing the light.
1. Remove the grease filters
2. Replace the lamp with a new lamp of the same type.
3. Replace the grease filters.
Lamp
Power (W)
Socket
Voltage
(V)
Dimension
(mm)
ILCOS Code
40
120
120
10
10
G
E
H
P
L
340
599
205
100
400
120
16
270
522
365
502
M
3 E14 220-240 102 x 35 DRBB/C-3-220-240
E14-35/102
MAINTENANCE