EN 22
ERRORS
Error codes
P1 P2 1/2 3h 6h
interference type solution
* * * *
Insufficient water
supply
• Make sure that the water faucet is completely
open and that there is no crack in the supply
hose
• Check if the supply hose is clogged
• Restart the dishwasher
• Please contact the service department if the
problem persists
* * *
Pressure system
failure
• Please contact the service department
* * *
Flooding safety
enabled
• Close the water faucet and contact the service
department
* * *
The dishwasher is
not pumping out
• Check if the drainage hose is connected
• Check the bottom filter and filter group
• Restart the dishwasher and terminate the last
selected program
• Please contact the service department if the
problem persists
* * * *
Heating error • Please contact the service department
* * *
Flooding sound
signal activated
• Turn off the dishwasher and close the water
faucet
• Please contact the service department
* *
Interference in the
electronics
• Please contact the service department
* * *
Temperature in the
machine is too high
• Please contact the service department
* * *
Interference of
heating sensor
• Please contact the service department
* * *
High voltage failure • Please contact the service department
* * *
Low voltage failure • Please contact the service department
Should the appliance become overfilled or exhibit excessive
leaking, shut off the inlet tap and alert the service department.
To Next Page
