EN 23
ERRORS
Error codes
Problem Potential causes Solution
FF Insufficient water supply • Make sure that the water faucet is completely open and that there
is no crack in the supply hose
• Check if the supply hose is clogged
• Restart the dishwasher
• Please contact the service department if the problem persists
F5 Pressure system failure • Please contact the service department
F3 Flooding safety enabled • Close the water faucet and contact the service department
F2 The dishwasher is not pumping out • Check if the drainage hose is connected
• Check the bottom filter and filter group
• Restart the dishwasher and terminate the last selected program
• Please contact the service department if the problem persists
F8 Heating error • Please contact the service department
F1 Flooding sound signal activated • Turn off the dishwasher and close the water faucet
• Please contact the service department
FE Interference in the electronics • Please contact the service department
F7 Temperature in the machine is too high • Please contact the service department
F9 Interference of divisor position • Please contact the service department
F6 Interference of heating sensor • Please contact the service department
HI High voltage failure • Please contact the service department
LO Low voltage failure • Please contact the service department
Call an authorised service if the problem still persists after the
controls or in case of any malfunction not described above.
To Next Page
Loading...
