1. After reading the manual, decide where you are going to install the unit.
2. Once the location has been chosen, place the amplifier into position. Use a felt
tip pen or a pancil and mark the four holes to be drilled for mounting. NEVER
use the amplifier as a template for drilling. It might be damaged! Take the amplifier
from the location and drill the four holes.
3. Fix the amplifier to MDF or wooden surface. AVOID FIXING IT TO THE AUTOBODY
or other conducting parts.
4. If possible, test the system to ensure it is operating correctly before the final
mounting.
5. Mount the amplifier using the supplied four self tapping screws.
Self Tapping Screws
INSTALLATION
4
To Next Page
Loading...
