Turn the bean-stop-lever 180° to the front to stop the
bean feed
Place the portafilter in the holder and grind until empty
(approx. 8.5g)
Disconnect the grinder from the power supply before
opening both locking levers and lifting the bean hopper
out of the holder
Close the locking levers and remove the portafilter holder
Write down the settings
Carefully turn the adjustment ring CCW all the way to the
stop and slowly pull it down and out (9)
Clean the grinding chamber and grinder with the brushes
Reassemble the adjustment in reverse order (observe the
marking - see Fig. 8)
Install the portafilter holder, open the
locking levers, place the bean hopper in
the holder and close the locking levers
Turn the bean-stop-lever to position OPEN
To remove any remains in between,
slowly turn the macro ring (with the
grinder running) to 0 and then back to
your settings
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
GRINDING PROCESS CLEANING
General information
Place the portafilter in the holder and press the desired button (1, 2, 3) followed by START (during the
grinding process, the grinding time in seconds or the weight in grams is displayed)
The grinder stops as soon as the programmed grinding time or weight is reached (+/- 0.1/0.2g)
To pause grinding, press START; to resume grinding, press START again. By pressing the START button
several times, the target weight can be reached in small steps (0.1-0.2g).
To grind in manual mode, press and hold the START button until a P (Purge) appears. You can now
continue by pressing the START button repeatedly (in approx. 0.5g increments) or keep the START
button pressed until the desired amount is reached. Press STOP to return to automatic mode.
W models:
To enter timed mode, press STOP and 1 simultaneously for 5
seconds. The programmed grinding time is displayed in seconds. A
vertical line on the left of the display confirms that you are in time
mode (6). To return to weight controlled mode, press STOP and 1
for 5 seconds.
The etzMAX is used to grind between 7 and 22g
When the temperature reaches 75°, the grinder switches off automatically
After the machine circuit breaker trips, determine and eliminate the cause of the trip before reactivating
it or the grinder (repeated blockages damage the system)
Do not grind light roasts or hard beans on Notch 1
Plastic cone holders are wear parts and must be replaced when worn to avoid damage to the system
(since March 2021 all grinders are being stocked with metal coneholders)
Clean your etzMAX regularly ( daily if used commercially) according to the instructions (additional video
instructions: www.etzinger-ag.com or YouTube: etzingergrinders)
If the etzMAX is in sleep mode, press any button to reactivate
Observe the SAFETY INSTRUCTIONS (attachment) and read them carefully prior to initial use!
Scale Mode
Time Mode
Email: support@etzinger-ag.com
Phone. +423 375 8383
www.etzinger-ag.com
To use the scale for weighing independently of grinding, press STOP for 5 seconds. The display changes to
0.00 (7). While you are in scale mode, all LEDs light up at the same time. For TARE press STOP. To return to
GbW mode, press STOP for 5 seconds.
Thank you for your purchase
For more detailed instructions
(Operating manual), visit our Website:
www.etzinger-ag.com
Fig. 6 Fig. 7
Fig. 8 Fig. 9
To Next Page
Loading...