6
Corresponds to EC
directives
Labelled electrical
product may not be
disposed of in the
household waste
symbol may only be
operated in the
house (dry
Insulated housing
(protection class II).
Fuse,
here: Slow-burning,
1.6A
Recommended
battery capacity
Read the operating
instructions
requirements of § 21
of the German
Product Safety Law
(Produktsicherheitsg
IP65
Protection class
Spray water
protected
Intended use
The charger is suitable for charging open and a variety of closed, maintenance-free lead-acid batteries, for example:
• Wet batteries (WET), lead-acid batteries (uid electrolyte)
• Gel batteries (gel electrolyte)
• AGM batteries (electrolyte in breglass eece)
• Maintenance-free lead-acid batteries (MF)
Other batteries may not be charged with this device.
The charger may not be used as a starter aid. First charge the battery of your vehicle fully and remove the charger
before starting the vehicle.
The charger may not be used as a source of direct current or for other purposes.
The battery charger is designed for use in dry and protected environments at temperatures of -5 °C to +40°C.
This device is not designed to be used by children and people with limited mental capacities or those without
experience and/or knowledge. Keep children away from the device.
The device is not designated for commercial use.
Any other use or modication to the device is considered improper usage and may be dangerous. EAL GmbH accepts
no liability for damages caused as a result of improper use.
Scope of delivery
Charger Operating instructions
Specications
Dimensions: 180 x 100 x 45 [mm] Weight: 0.475 kg Long mains cable: 1.50 m Long charger cable: 1.50 m
Input: 220-240 V AC 50/60 Hz Output: 6 V mode: 6 V DC 2.0 A
Motorbike: 12 V DC 2.0 A Auto: 12 V DC 4.0 A
Battery capacity: 6 V min 1.2 Ah max. 14 Ah
12 V min 1.2 Ah max. 120 Ah
Protection class: IP65 (only device housing, not connection and charging cable)
Ambient temperature: -5 °C to +40 °C
Explanation of symbols
Safety notes
The warning triangle labels all instructions important to safety. Always follow these otherwise you could
injure yourself or damage the device.
Only connect the device to a correctly installed socket. The voltage must correspond to the specication