eufy Security Garage-Control Cam User Manual

1817
APPENDIX. REPLACING
BATTERY FOR SENOR
6
1. Pull the sensor off the battery cover.
2. Remove the battery using the provided detaching pin.
Press the battery with your finger when detaching to
keep the battery from suddenly popping out.
To show the door open/closed status correctly
in the eufy Security app, perform a calibration on
Camera Settings
>
Door Settings
>
Calibration
after you replace the battery or move the sensor.
NOTICE
7
CAUTION RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE. DISPOSE
OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS
ATTENTION RISQUE D'EXPLOSION SI LA
BATTERIE EST REMPLACÉE PAR UN TYPE
INCORRECT. ÉLIMINER LES BATTERIES USÉES
SELON LES INSTRUCTIONS
Warning:
– replacement of a battery with an incorrect type that
can defeat a safeguard;
– disposal of a battery into fire or a hot oven, or
mechanically crushing or cutting of a battery, that can
result in an explosion;
– leaving a battery in an extremely high temperature
surrounding environment that can result in an
explosion or the leakage of flammable liquid or gas;
and
– a battery subjected to extremely low air pressure
that may result in an explosion or the leakage of
flammable liquid or gas.
Attention:
– remplacement d’une batterie par un type incorrect
pouvant supprimer une protection
– mise au rebut d’une batterie dans un feu ou dans un
four chaud, ou écrasement mécanique ou coupure d’une
batterie, susceptible de provoquer une explosion;
– maintien d’une batterie dans un environnement
à très haute température pouvant provoquer une

eufy Security Garage-Control Cam Specifications

General

Brand	eufy Security
Model	Garage-Control Cam
Category	Security Camera
Language	English