NOTICE
FCC
Statement
This device complies with Part 15
of
the
FCC
Rules.
Operation
is
subject
to
the following two conditions: (1) this device may
not
cause harmful
interference, and
(2)
this device must accept any interference received,
including interference that may
cause
undesired operation.
Warning: Changes
or
modifications not expressly approved by the party
responsible
or
compliance could void the user's authority
to
operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for
a
Class
B digital device, pursuant to Part 15
of
the
FCC
Rules.
These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and
can
radiate radio frequency energy
and,
if
not
installed and used in accordance with the instructions, may
cause harmful interference
to
radio communications. However, there
is
no guarantee
that
interference will not occur in a particular installation.
If
this equipment does
cause
harmful interference to radio
or
television
reception, which
can
be determined by turning the equipment
off
and on,
the user
is
encouraged
to
try
to correct the interference by one
or
more
of
the following measures:
(1)
Reorient or relocate the receiving antenna.
(2) Increase the separation between the
equipment
and receiver. (3)
Connect the equipment into
an
outlet
on
a circuit different
from
that to
which the receiver
is
connected.
(4)
Consult the dealer
or
an
experienced
radio/TV technician
for
help.
FCC
Radio Frequency Exposure Statement
The
device
has
been
evaluated
to
meet
general
RF
exposure
requirements. The device
can
be used in fixed/mobile exposure
condition.
The
min separation distance
is
20cm.
12
To Next Page
Loading...
Need help?
General
