EUFY C1 - Weight-Only Measurement; Maintenance; Troubleshooting; Error Messages

04 05
English
English
When Measuring
Issue Cause Solution
Abnormal measurement
results:
• Too high
• Too low
• Huge dierence
between two recent
measurements
• Incorrect posture.
Step onto the scale barefoot and
stand still.
• Device is placed on
soft carpeting or
uneven surface.
Place the device on a hard and flat
surface.
LED display does not turn
on after stepping onto the
scale.
• Batteries not
installed.
• Install three new batteries.
• Worn batteries.
• Replace all three batteries at the
same time.
Scale does not proceed to
analyse body composition.
• Taking
a measurement while
wearing shoes or
socks.
• Stand barefoot on the scale and
keep feet in full contact with
the electrodes when taking a
measurement.
Specifications
Product Model T9146
Power Source 4.5 V (3 × AAA batteries)
LED Display 67 × 29 mm / 2.6 × 1.2 in
Measurement Unitse Pound / Kilogram
Unit Increments 0.1 lb / 0.1 kg
Body Fat Unit Increments 0.1 %
Body Water Unit Increments 0.1 %
Muscle Mass Unit Increments 0.1 %
Measurement Range 11-397 lb / 5-180 kg
Working Environment
Temperature: 5 - 40 °C
Humidity: 20 - 90% RH
Storage Environment
Temperature: -20 - 50 °C
Humidity: <= 90% RH
Operating Frequency Range 2402 - 2480 MHz
Radio-Frequency Power 4 dBm
Dimension 280 × 280 × 23 mm / 11.0 × 11.0 × 0.9 in
Net Weight 3.31 lb / 1. 5 kg
Weight-Only Measurement
This scale can also be used as a conventional weight-reading scale. You can
simply step on the scale to measure your current weight without opening the
EufyLife app.
Maintenance
Regularly clean the scale with a dry or slightly dampened soft cloth.
- Do not wash the scale with water or immerse it in water.
- Never use detergents to clean the scale as this may cause it
to malfunction or discolor.
Troubleshooting
Error Message
Error Display Description Solution
Overload. The device will power o. Stop using this scale for measurement.
Low battery. The device will
power o.
Replace all three batteries at the same
time.
Measurement failure.
• Step barefoot and keep full contact
with the electrodes.
• Stand still until the measurement on
the LED display locks.