04 05
What’s In the Box
Smart Scale P1 AAA Battery (×3) Owner’s Manual &
Other Documents
Inserting the Batteries
Turn the scale over and place it on a flat surface.
Open the battery door and insert three AAA batteries. Make sure the
positive and negative ends are facing the correct polarity directions
marked in the battery compartment.
- The digits “ ” will show on the LED display.
Close the battery door and wait until the digits “ ” are shown on the
LED display.
will appear on the LED display when the batteries are low.
Replace all three batteries at the same time. Do not mix new and used
batteries.
Declaration of Conformity
This product complies with the radio interference requirements of the European
Community. Hereby, Anker Innovations Limited declares that the radio equipment
type T9147 is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
https://www.eufylife.com/.
Maximum output power: 4 dBm
Frequency band: 2.4G band (2.4000GHz - 2.4835GHz)
To Next Page
Loading...
