3. Preparing Your S1
3.1 Remove Stickers and Foam Packaging
Before using, remove the stickers, laser protection film, and foam packaging from the robot and Uniclean™ Station.
3.2 Install Side Brushes
Make sure the brushes marked 1 (red) and 2 (gray) are correctly installed based on the diagram below. You will hear
a "click" when the side brushes are in place.
3.3 Connect to Power Supply
Firmly insert the power cord as shown in the diagram. Tuck any excess cable into the winding groove.
Once the base station is connected to power, the Touch Panel and LED ring in the clean water tank will light up.
To Next Page
Loading...
