03 04 05 06
explosion or leakage of flammable liquids or gases..
Attention:
• Le remplacement d’une batterie par un type incorrect peut contourner
les protections et créer un danger ;
• L’élimination d’une pile dans un feu ou une autre source de chaleur
importante, ou par écrasement ou découpage, peut entraîner une
explosion ainsi qu’une fuite de liquides et de gaz inflammables ;
• Le fait de laisser une batterie dans un environnement extrêmement
chaud peut entraîner une explosion ainsi qu’une fuite de liquides et de
gaz inflammables ;
• Une batterie soumise à une pression d’air extrêmement faible peut
provoquer une explosion ainsi qu’une fuite de liquides et de gaz
inflammables.
CAUTION!
THERE IS A RISK OF EXPLOSION IF AN INCORRECT BATTERY TYPE
IS USED. DISPOSE OF USED BATTERIES ACCORDING TO THEIR
INSTRUCTIONS.
ATTENTION!
RISQUE D'EXPLOSION SI LA BATTERIE EST REMPLACÉE PAR UN
TYPE INCORRECT. ÉLIMINER LES BATTERIES USÉES SELON LES
INSTRUCTIONS.
This product complies with the radio interference requirements of
the European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in
compliance with the essential requirements and other relevant provisions
of Directive 2014/53/EU. For the declaration of conformity, visit the web
site: https://support.eufy.com/s/articleRecommend?type=DownLoad&se
condType=doc.
RF Exposure Information
The Maximum Permissible Exposure (MPE) level has been calculated based
on a distance of d=20 cm between the device and the human body. To
maintain compliance with RF exposure requirement, use product that
maintain a 20cm distance between the device and human body.
Frequency bands and power are as below:
Function Bands Operation
Frequency
Maximum Power
Wi-Fi 2.4GHz 2412-2472MHz EIRP 19.10 dBm
Bluetooth 2.4GHz 2402-2480MHz EIRP 8.0 dBm
The following importer is the responsible party (contract for EU matters):
Anker Innovations Deutschland GmbH I Georg-Muche-Strasse 3, 80807
Munich, Germany
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by one or more of
the following measures: (1) Reorient or relocate the receiving antenna. (2)
Increase the separation between the equipment and receiver. (3) Connect
the equipment into an outlet on a circuit dierent from that to which the
receiver is connected. (4) Consult the dealer or an experienced radio/TV
technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements.
The device can be used in fixed/mobile exposure condition. The min
separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made using shielded
cables to maintain compliance with FCC regulations.
The following importer is the responsible party
Company Name: POWER MOBILE LIFE, LLC
Address: 10900 NE 8th St, Ste 501, Bellevue WA 98004
Telephone: 1-800-988-7973
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
IC Radiation Exposure Statement
When using the product, maintain a distance of 20cm from the body to
ensure compliance with RF exposure requirements.
Lors de l'utilisation du produit, maintenez une distance de 20 cm du corps
afin de vous conformer aux exigences en matière d'exposition RF.
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
This symbol means the product must not be discarded as household
waste, and should be delivered to an appropriate collection facility
for recycling. Proper disposal and recycling helps protect natural
resources, human health and the environment. For more information
on disposal and recycling of this product, contact your local
municipality, disposal service, or the shop where you bought this
product.
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong
Kong
Customer Service
18-month limited warranty
support@eufy.com
service@myeufy.com.au (AU)
(US/Canada) +1 (800) 988 7973
(AU) +61 3 8331 4800
@EufyOfficial@EufyOfficial @EufyOfficial
To Previous Page
Loading...
