Eureka E110 Scrubber Dryer
Operator Notice
This notice serves as a quick guide to
important points to remember
The machine should be used by authorised
trained operators only
All operators must read & understand the
operator manual prior to use
BEFORE USE
▪ Check battery connector is plugged in
▪ Check key is inserted correctly
▪ Check battery charge level
▪ Check brushes/pad holders
▪ Check splashguard
▪ Check squeegee rubbers
▪ Check tanks
▪ Check recovery tank gasket cover
OPERATION
▪ Release the parking brake
▪ Turn key to position 1
▪ Press on/off button
▪ Brushes & vacuum motors will switch on when pedal is pressed
▪ If necessary adjust detergent solution using + & - buttons
▪ Lubricate the splashguard blades by slowly moving back & forth for 1 metre
▪ Do not stop the machine over the same area with brushes spinning (could damage the floor)
▪ If the floor is particularly dirty, use the increased brush pressure function by pressing the button
▪ At the end of each washing operation, lift the brushes, turn the brush switch off and continue with the
squeegee down to complete drying the floor
▪ Lift the squeegee & wait several seconds before switching off the vacuum, this will stop any water
droplets falling onto the floor
AFTER USE
▪ Drain & rinse the tanks
▪ Check brushes/pads
▪ Clean squeegee
▪ Clean mesh filter (in recovery tank)
▪ Clean solution & vacuum filter (weekly)
DO NOT
▪ DO NOT use anything other than low foam detergent in the machine
▪ DO NOT opportune charge (e.g. at tea breaks etc, only charge when the machine is flat)
▪ DO NOT use the machine on an unswept floor
▪ DO NOT use hot water in the machine (cold/lukewarm only)
To Next Page
Need help?
General
