How to Check and Clear Hose Blockages
Low suction or poor pickup may be due to a blockage in the vacuum cleaner.
1. Remove hose and check suction at end of hose - if little or
no suction, check disposable dust bag. Change if needed.
If no improvement proceed to step 2.
NOTE: Turn off the switch and unplug the electrical cord
before clearing hose.
2. Remove the handle from the vacuum cleaner by removing
the two screws and sliding the handle towards the rear.
3. Once the handle is removed, disconnect the attachment
hose from the unit by lifting straight up on the hose adapter.
Check for any obstructions that may be in the hose. Any
obstructions can be removed by using a blunt instrument to
clear the hose. Flexing the hose may help loosen the clog.
4. Reinstall the hose after clearing the clog. Make sure the
hose is inserted into the top of the vacuum cleaner before
reattaching the handle.
NOTE: If no improvement in performance on carpet, proceed
to following page.
2. Remove handle.
3. Disconnect hose.
..
..
.
1. Remove hose and check suction at end of
hose.
##
##
#
4. Reinstall the hose and handle.
1
2
4
##
##
#
3
13
To Next Page
Loading...
