20 / 32
GIVE US A CALL: 1-844-416-2090
MON-FRI 8:30AM - 5:30PM (PT)
customerservice@eurekaergonomic.com
ERROR CODE
ERROR CODES CAUSE SOLUTION
E01、E06、E07
Faulty power supply
of thecontrol box
Unplug the desk and plug it back in after 10 seconds. lf the code still exists,
the controlbox is faulty. Please contact our local customer service team for
replacement parts.
E02 Unbalanced legs Reinitialize
E04
Hand controller connection
or communication error
Check hand control cable
E05 stop in case of obstruction Release the button and run again
E08 Desktop tilts protection Reinitialize
HOT Overheat protection Please wait for the temperature to drop before use.
E12 、E42、E43 Overload or motor failure Replace control box
E15 、E25 Desk leg failure If it cannot be eliminated after restarting, replace the desk legs.
E16 、E26 Leg Stuck Reinitialize
E18 、E28
The load is too large,
overloaded
Reduce load
E14 、E17、
E24 、E27
Desk leg position sensor
abnormality
Press the "+" key or the "-" key again. If the problem persists, please check
whether the plug wire of the table leg is inserted in place.
E11、E13、
E21、 E23
Loose connection between
the legs and the control box
Check the connection cable
To Next Page
Loading...