Why is the flame too high on High setting on my Euro Appliances Cooktop?
The flame might be too high due to a faulty regulator, an incorrect injector, or using an incorrect utensil size. Refer to operating instructions for proper utensil choice; for regulator or injector issues, it is recommended to call an authorised representative.
Why is there no spark when I depress the gas control knob on my Euro Appliances ECT600GS?
The possible causes could be: no power, a loose sparker cable, or a burner that is not aligned properly. First, check if the cooktop is plugged in and switched on, and that the mains circuit breaker is working. If the sparker cable is loose, or burner is not aligned properly, remove and refit burner, it is recommended to call an authorised representative.
What to do if burner not lighting when spark ignition working on Euro Appliances ECT600GS Cooktop?
If the burner is not lighting, it could be due to the gas supply being off, the burner not being aligned properly, or blocked burner ports. Ensure the gas supply valve is on. Remove and re-fit the burner to make sure it is aligned. If the burner ports are blocked, remove, clean, and replace the burner.
Why is the flame small on High setting on my Euro Appliances Cooktop?
A small flame on the high setting may be due to a faulty regulator, low gas supply pressure, an incorrect injector, a blocked injector or gas supply tube, or using an incorrect utensil size. Refer to the operating instructions for utensil choice. For other issues, it is recommended to call an authorised representative.
What to do if burner goes out when control knob released on Euro Appliances ECT600GS?
If the burner goes out when the control knob is released, it may be because the flame safeguard was not activated or there is a faulty connection/broken flame safeguard. Try re-lighting the burner and allow more time for the flame safeguard to activate. If the issue persists, it is recommended to call an authorised representative.
Why is there an uneven flame pattern on my Euro Appliances Cooktop?
An uneven flame pattern or slight flame lifting is usually caused by blocked burner ports. Remove, clean, and then replace the burner to resolve this issue.
What to do if at minimum flame setting the flame is too high on Euro Appliances Cooktop?
If the flame is too high at the minimum setting, the turndown control setting is incorrect. It is recommended to call an authorised representative.
General| Brand | Euro Appliances |
|---|---|
| Model | ECT600GS |
| Category | Cooktop |
| Language | English |
To Next Page
