Why my Euroflex Ultrasonic Jewelry Cleaner hand vacuum will not operate?
If your Euroflex Ultrasonic Jewelry Cleaner hand vacuum won't operate, first, ensure the power cord is firmly plugged into the outlet. If it is, check your fuse or breaker to ensure the wall outlet has power. If neither of these resolves the issue, your appliance may need maintenance.
Why Euroflex Ultrasonic Jewelry Cleaner hand vacuum has weak suction?
If your Euroflex Ultrasonic Jewelry Cleaner hand vacuum has weak suction or isn't picking up, the dust cup might be full. Empty the dust cup filter. Also, the unit could be clogged. Turn it off, unplug it, remove the dust cup filter, and check the air duct or hose for obstructions. Remove any you find.
What to do if dust escaping from Euroflex Ultrasonic Jewelry Cleaner?
If dust is escaping from your Euroflex Ultrasonic Jewelry Cleaner hand vacuum, it could be that the dust cup filter is full. Try cleaning or replacing the dust cup filter. Also, check that the dust cup filter is correctly installed, reviewing the instructions if needed. Finally, inspect the dust cup filter for any punctures or holes, and replace it if damaged.
How to fix Euroflex Ultrasonic Jewelry Cleaner if hose or brushes will not pick up?
If the hose or brushes on your Euroflex Ultrasonic Jewelry Cleaner won't pick up, start by removing the hose and/or brushes. If that doesn't work, the hose could be clogged; remove any obstructions. Alternatively, the dust cup filter might be full. In this case, empty and clean the dust cup filter.
General| Tank Capacity | 600 ml |
|---|---|
| Ultrasonic Frequency | 42 kHz |
| Power | 50 W |
| Frequency | 42 kHz |
| Timer | 5 preset cleaning cycles |
To Next Page