d) Put the choke lever in the position (CHOKE).
This is not necessary if the engine is still warm.
e) When you use the generator for the first time,
press the fuel pump 6 times to pump petrol into
the carburettor.
f) Pull the pull cord slowly until you feel resistance.
This is the “compression point”. Allow the lever to
return to the starting position and now pull
quickly. While doing so, hold the generator firmly
in position using the lever to prevent it from
falling over while pulling the pull cord. Do not pull
the cord out entirely. After starting, allow the pull
cord to return to its starting position while holding
the lever. Repeat as necessary if the engine does
not start with the first pull.
Caution: The pull cord may be pulled back very quickly and with force before
you have released it. This may pull your hand with force in the direction of the
generator, possibly injuring your hand.
Do not allow the lever to snap back. Ensure the lever rolls up slowly.
g) Allow the engine to warm up.
h) Return the choke lever to the operating position
(RUN).
i) Give the generator a few minutes to warm up
properly without a load.
To Next Page
Loading...
