Position of the Drain and Water
Supply hoses before disassembling.
ASSEMBLY AND DISASSEMBLY METHODS FOR KEY
COMPONENTS
1) DRAIN HOSE
For the purpose of avoiding any
siphonage in the drain hose, the
hose is kept at a certain sufficient
level by means of 1 hose clamp.
This clamp should never be
removed while assembling the
machine in the desired position.
When the hose is to be replaced, the unit, which is seen at the right back top
corner of the machine is required to be removed after being cut.
3 wire clamps and 2 plastic hose clamps are removed for dismantling the
drain hose.
2) TOP PLATE
The plate is pulled back for approximately 1 cm. by pressing the latches
located at both sides of the upper plate in upward direction. Afterwards, the
plate is removed by pulling it upwards.
The position of the drain hose during the
assembly of the product.
Manner of opening the latch of the upper
plate.
Manner of removing the upper plate after the
latches are released.
To Next Page
Need help?
General
