• Quick blinking (4 times a second) – controller error (switching off due to lack of LPG in the
tank)
• On – the vehicle uses LPG
Push button – for change of fuel type
Programming of fuel type:
The controller “remembers” last fuel type setting before switching the ignition switch off.
Caution:
In older controller software versions setting of the controller status is performed when the ignition
key is turned on and engine off; then the set controller operation mode is saved. Fuel change when
the engine works is just momentary and will not be saved.
4.2. Acoustic signals
The controller generates following acoustic signals:
• Triple acoustic signal – during switchover to gasoline if the LPG level in the tank is too low.
• Three short and one long acoustic signals – if a controller error occurs.
To Previous Page
Loading...
