• If an extension cord is absolutely necessary, a 10 ampere (Europe) or 15 ampere (America) cord should
be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it
cannot be pulled or tripped over.
• Do not use sparkling (carbonated) water. If your water supply is very hard, we suggest you use demineralised
water instead.
• When the iron is hot, do not rest it onto the connecting cable or the power cord. Take special care in ensuring
that the cable and the cord do not come into contact with the soleplate when it is hot.
• Do not pull the power cord to unplug the appliance.
• The appliance must only be cleaned with a soft, slightly damp cloth after unplugging the iron and allowing all its
parts to cool down. Never use solvents which may damaged the plastic parts.
• Clean the boiler at least every three months so as to eliminate any residue of time that could jeopardize proper
operation of the appliance.
• Do not pour descalers or other scented substances into the tank; under penalty of immediate cancellation of the
warranty.
• Do not wrap the power cord around the soleplate when the iron is hot.
• Do not put the soleplate in contact with metal surfaces.
• The boiler cap contains a safety device (set so that it triggers in the event of excess pressure in the boiler) and
must only replaced with an original spare part.
• To maintain the iron in good working order, disconnect the plug from the outlet at the end of every ironing
session, discharge the inside pressure by turning the grey dial around the steam button to the right until all
steam is released. Unscrew the safety cap and let the residual water in the tank evaporate. Empty the boiler.
• We decline any responsibility resulting from misuse or any use other than those covered in this booklet.
SAVE THESE INSTRUCTIONS IN A SAFE PLACE
AT ALL TIMES
Notes: when using the iron for the first time, test it on an old piece of fabric to ensure that the soleplate and the
water tank are completely clean.
DESCRIPTION OF THE APPLIANCE (FIG. A)
1 - Safety Cap
2 - Steam Control Knob
3 - Cap Remover
4 - Steam Push Button
5 - Ready Light
6 - Power Cord
7 - Temperature Regulator
8 - Soleplate
9 - Boiler
10 - Teflon Iron Resting Pad
11 - Funnel
12 - Measuring Jug
HOW TO USE AS STEAM IRON (AS DEMONSTRATED)
FILLING WITH WATER BEFORE IRONING
- Make sure that the iron is disconnected from the power supply before filling.
- Place the iron on the iron base (10) in a horizontal position and use the provided measuring jug (12) and funnel
(11) to fill the boiler. see Fig. B
- ENSURE THAT THE AMOUNT OF WATER NEVER EXCEEDS 210ml or 3/4 cup of water, that is the exact
amount indicated on the measuring jug; if the amount in the boiler tank is greater that 210ml water may leak
and/or spurt from the iron’s plate at the beginning of the ironing session.
- Do not fill the boiler tank with chemical additives or other perfuming or decalcification agents.
- Pour any remaining water out after use.
To Next Page
Loading...
