BEFORE IRONING
Ensure that the safety cap on the boiler is well tightened. Turn the cap until it stops and then tighten slightly
without applying too much strength to avoid breaking the gasket, which would cause the steam to leak out.
HOW TO PRIME THE BOILER
- Fill with water using measuring cup.
- Wait until light turns off.
- Turn grey dial fully to right (continuous steam).
- Wait until the reservoir is empty and steam runs out.
- If you see excessive water during priming it is normal.
HOW TO START THE APPLIANCE
- Insert the plug into the outlet. Turn the thermostat to the #9 position, as shown in figure C.
- When the ready light (5) goes on the iron is heating up.
- Wait for 4-5 minutes until the warning light goes off.
- Now you may start to steam iron.
- If light goes back on while ironing, continue ironing.
STEAM IRONING
You may use this iron in a vertical position when smoothing out hanging clothes or on the board.
STEAM OUTFLOW
The steam outflow may be DISCONTINUOUS or CONTINUOUS.
- DISCONTINUOUS STEAM: The Steam Control Knob (2) must be turned counter-clockwise. Press the push
button (4) shown in figure D by applying more or less strength according the amount of steam desired. This will
provide the best results.
- CONTINUOUS STEAM: Turn the Steam Control Knob clockwise as shown in figure E to obtain a constant and
continuous steam. Maximum intensity can also be obtained in the DISCONTINUOUS outflow by fully pushing the
steam push button (4).
- Never overturn the iron or tilt it forward or laterally while it is being used either in the discontinuous or continuos
mode.
- Continuous steam is mainly used for draining water when iron is till hot.
We recommended you use the iron in the DISCONTINUOUS mode as you will use the least amount of
water and will get the most powerful steam in this mode.
ATTENTION
ALWAYS stop the steam out flow before resting the iron on the separate base (10).
NEVER unscrew the safety cap (1) while the iron is being used. Always turn the iron off first. Removing the plug
from the outlet (4) to use continuous steam to let out all the residual steam.
HOW TO FILL THE BOILER WHILE THE APPLIANCE IS BEING USED
If you need to fill the boiler during an ironing, the following operations should be carried out:
- Remove the plug from the outlet.
- Fully press the push button (4) to let out all residual steam
- Unscrew the safety cap (1) this operation is made easier with the safety cap remover supplied.
- SLOWLY pour a small amount of water into the boiler tank 2-3 times to allow the steam to come out of the
filling tube. Then fill the boiler as usual.
- Screw the safety cap on tightly.
- Insert the plug into the outlet.
- Steam will recommence after a short time.
Remember that the amount of water to be poured into the boiler tank while the iron is being used should
not exceed 210ml or 3/4 cup as indicated on the measuring jug. To ensure the right quantity of water is
poured into the boiler tank, always drain the tank before refilling.
TIPS AND SUGGESTIONS FOR STEAM IRONING
- When using a vertical (hanging) position gently skim fabric (lightly touch) with iron while pushing and releasing
white steam button. Ideal for all clothing while hanging or draperies while hanging.
To Next Page
Loading...
