Need help?Do you have a question about the Eurotherm 2132i and is the answer not in the manual?
General| Type | Temperature Controller |
|---|---|
| Model | 2132i |
| Accuracy | ±0.1% of span |
| Enclosure Rating | IP65 |
| Input Type | Thermocouple, RTD |
| Output Type | Relay |
| Communication | RS485 |
| Power Supply | 24V AC/DC |
| Operating Temperature | 0°C to 50°C |
General guide for installing and operating the indicator units.
Details physical dimensions and panel mounting procedures.
Explains wiring diagrams for different models and power supply.
How to switch on the unit and view display unit information.
Explains alarm indication (OP1/OP2) and how to acknowledge new alarms.
Lists alarm messages and diagnostic codes with their meanings.
Procedure for changing parameter setpoints or trip levels.
Steps for user calibration, including 2-point calibration.
How to select and adjust parameters within the parameter lists.
Details on user calibration, including 2-point calibration.
How to hide or make parameters read-only for security.
Steps to enter and leave configuration modes.
Setup for internal alarms and relay/logic I/O.
Settings for sensor input, display units, and password protection.
Breakdown of the ordering code parameters.
Summary of technical data including display, supply, and environmental specs.
Information on safety, EMC, unpacking, storage, and service.
Safety symbols, personnel, wiring, and power isolation requirements.
To Next Page
