To Next PageTo Next PageWhy Eurotherm 512C/04 Media Converter motor runs at full speed only?
The Eurotherm Media Converter motor might be running at full speed only due to several reasons: * Incorrect Tachogenerator Polarity or Open Circuit Tachogenerator: Check Tachogenerator viability and connectivity. * Open Circuit Speed Setpoint Potentiometer: Check Terminal 13 or 10 as appropriate. * Minimum Speed Setting: Check Minimum Speed Potentiometer P6.
What to do if Eurotherm Media Converter motor runs and stops with stall LED illuminated?
If the Eurotherm Media Converter motor runs and stops after a short period, and the "Stall" LED1 is illuminated, consider these potential causes and solutions: 1. Incorrect Current Limit Setting: Check P4 setting and the external current limit setting. 2. Incorrect Current Calibration: Check Programming Switches SW5, 6, and 7. 3. Motor Jammed: Free any obstruction. 4. Incorrect Feedback Voltage Calibration: Check Feedback Voltage Calibration Switches SW1/2. Note that these switches must be set for both Tachogenerator & Armature Voltage Feedback. 5. Maximum Controller Output Exceeded: Check compatibility of Motor Voltage to Controller Output Voltage. 6. Faulty Tachogenerator and/or Coupling: Check Tachogenerator (use Armature Voltage Feedback Temporarily).
What to do if Eurotherm 512C/04 motor will not run at switch on?
If the Eurotherm Media Converter motor will not run when switched on, consider the following possible causes and solutions: * Start/Run Signal not present: Check Control Circuit Wiring. * No Speed Setpoint: Check Total Setpoint terminal 12. Check Setpoint Potentiometer & Wiring. * No Armature Current: Check P4 adjustment & External Current Limit Potentiometer setting & wiring (if used). * No Field: Check Field AC Supply and Field connections. * Motor Jammed: Free Obstruction.
General| Brand | Eurotherm |
|---|---|
| Model | 512C/04 |
| Category | Media Converter |
| Language | English |
