_________________________________________________________ _________________________________________________________
Instruction Manual MM850518 ed.01
______________________________________________2_______________________________________________
INTRODUCTORY NOTE
This manual has been with all the information you need to install, operate and maintain the dry block temperature
calibrator MicroCal T100+/T500+/T1100+ and its accessories.
Eurotron has used the best care and efforts in preparing this book and believes the information in this publication are
accurate. The Eurotron products are subjected to continuous improvement, in order to pursue the technological
leadership; these improvements could require changes to the information of this book.
Eurotron reserves the right to change such information without notice.
No part of this document may be stored in a retrieval system, or transmitted in any form, electronic or mechanical,
without prior written permission of Eurotron Instruments SpA.
MicroCal T series calibrators use sophisticated analogic and digital technologies. Any maintenance operation must be
carried out by qualified personnel
ONLY. Eurotron supplies instructions and operative procedures for any operation on
the instrument. We recommend to contact our technicians for any support requirements.
MicroCal T is fully tested in conformity with the directive n°89/336/CEE Electromagnetic Compatibility. Eurotron shall
not be liable in any event, technical and publishing error or omissions, for any incidental and consequential damages, in
connection with, or arising out of
the use of this book.
All right reserved
Copyright © 1998, 2004
EUROPEAN Headquarters
Eurotron Instruments SpA
Viale F.lli Casiraghi 409/413
20099 Sesto S. Giovanni (MI)
Tel. : +39-02 24 88 201
FAX: +39-02 24 40 286
Mail: info@eurotron.com
USA Headquarters
E-Instruments Group LLC
172 Middletown Blvd – Suite B201
Langhorne, PA 19047
Tel.: 215 750 1212
FAX: 215 750 1399
Mail: info@einstrumentsgroup.com
WARNING
Hazardous voltage are present in this electrical equipment during operation.
Non-observance of the safety instruction can result in severe personal injury or property damage.
Only qualified personnel should work on or around this equipment after becoming familiar with
all warnings, safety notices, and maintenance procedures contained herein.
Only qualified personnel or our personnel should work on this equipment for maintenance
operation.
The successful and safe operation of this equipment is dependant on proper handing, operation
and maintenance.
To Next Page
