Eurotronic EOS 30 User Manual

EOS 30
ENG REV 02
Warning
Dear customer, thank you for having purchased a product from EUROTRONIC. This instructions sheet contains important information about the
ways of use and the safety of the installation. Follow the instructions and keep them for future reference.
Radio devices cannot be used in the places that have factors of influence such as: close to police stations, airports, banks and hospitals.
It is important to carry out a technical control before using radio system. Only use radio frequency when you do not create problems to the
functioning of the receivers and the emitters.
If more than one installation are functioning in the same frequency, both could be blocked and could not work properly.
Technical features:
 Feeding:
 Temperature of work
 Dimensions
 Channels
 Grups
 Daily programms
 Rolling code
 Frequency
1 battery 3 V type CR 2032
0°C ÷ + 50°C
42 x 135 x 18 mm:
1
8
Yes
Yes
433,92 MHz
Push buttons:
 PROG
 CH-
 CH+
 ▲
 ▼
 STOP
 STOP+ CH+
To record programs in the receivers
To select previous channel
To select following channel
UP
DOWN
STOP
To activate and deactivate sun function
(whenever it gets ready of captor of the sun)
To activate and to deactivate sun function:
To activate sun function: press STOP button and + during 4 seconds until the led light turns on. The remote control will emit an order to the
receiver and then sun function will be activated.
To deactivate sun function: press STOP button and + during 4 seconds until the led light turns off. The remote control will emit an order to the
receiver and then sun function will be deactivated.
Battery replacement:
EOS 30 is feed by two 3 V battery CR 2032 type. To replace the battery open the low lid of the emitter EOS 1 and extract the exhausted battery
replacing it by a new one. Replace the lid to its initial position.
Attention there is danger of explosion if the battery is replaced with an wrong type of battery. Make sure that you dispose of old batteries
into suitable container.
All the products and the specific skills quoted in this document are submitted to changes without previous notice.
Except personal authorizations and specific cases previously reconciled by EUROTRONIC, the device has to be used exclusively with
EUROTRONIC receivers.
EUROTRONIC can not be considered to be in charge of possible damages caused by improper, erroneous use or unreasonable cases.
EOS 1
LED
SUBIDA
CH -
STOP
CH +
BAJADA
PROG

Eurotronic EOS 30 Specifications

General

Model	EOS 30
Category	Remote Control
Power Supply	Battery
Battery Type	2 x AAA
Display	LCD
Range	30 meters
Functions	Child lock

Summary

Technical Features Overview

Device Specifications

Lists key technical specifications including power, temperature, dimensions, channels, groups, and frequency.

Remote Control Button Functions

Details the primary functions of the remote control's individual buttons like PROG, CH-, CH+, and STOP.

Sun Function Operation

Explains the procedure to activate and deactivate the sun function using the remote control.

Programming Menu Functions

Accessing the Program Menu

Instructions on how to enter and navigate the transmitter's programming menu using the STOP button.

Programming Time and Day

Guides on setting the current hour, day, and manual mode days for event schedules.

Channel and Group Configuration

Details on enabling/disabling active channels and grouping individual channels for synchronized operation.

Setting Automatic Schedules

Instructions for configuring time schedules, actions, and channel reactions for automatic operations.