EV Rider S19AF - Unfolding and Folding the Scooter

UNFOLDING THE SCOOTER
1. Position the scooter with rear wheels and anti-
tip wheels on the ground (as shown b elow) :
2. Insert the key in to the ignition of the scooter
and switch the scooter on .
3. The green button (green
arrow below) on the
s coote r should now be
illu m i n a te d . Press it then
release the button
and the scooter will
automatically unfold .
A lte rn a ti vely , press
the green button on
the re m ote .
(In case of emergency , press the red button on the
rear of the scooter to stop the un folding
proced u re . If this ha pp en s , remove the hazard and
keep your finger on the green button until the
scooter is fully unfolded) .
4. Switch off the
scooter using
the key and lif t
up the
b a ck re s t
(highlighted
in the picture
right)
FOLDING THE SCOOTER
1. Turn the key off and dismount the scooter.
2. Fold down the b a ck re s t of the s e a t ( h i g h li g h te d
on the picture b elow) .
3. The red button (red
arrow below) on the
s coote r should now be
i llu m i n a te d . Press it,
then r ele as e
the button and the
scooter will a u tom a ti ca ll y
fold .
A lte rn a ti vely , press the
red button on the r em ote .
(In case of emergency , pre ss
the green button on the rear
of the scooter to stop the
folding proced u re . If t h i s
h a pp en s , remove the hazard
and keep your finger on the
red button until the scooter i s
fully folded ).
4. Switch the scooter off using the ignition and
remove the key .