Need help?Do you have a question about the EVA single timber bed frame and is the answer not in the manual?
Lists all parts included with the single timber bed frame, including legs, screws, rails, and slats.
Guidance on positioning the timber bed frame against a wall before assembly, with contact info for alternatives.
Instruction to screw one leg into the middle rail and optionally attach felt pads to the leg's underside.
Align and connect the top, bottom, and side rails, ensuring the top rail is closest to the wall.
Screw the remaining four legs into the corners of the assembled frame for stability.
Carefully turn the assembled bed frame structure to stand upright on its legs.
Place the central support section onto the main frame of the bed.
Use frame hand screws and washers to firmly connect the assembled frame sections.
Place the headboard component into its designated slot within the bed frame.
Fasten the bottom of the headboard to the frame using headboard hand screws and washers.
Attach the back of the headboard to the frame using two headboard hand screws.
Stick two thick felt pads onto the back of the headboard to prevent wall damage.
Place the bed slats onto the frame and a caution to avoid standing on them.
General| Brand | EVA |
|---|---|
| Model | single timber bed frame |
| Category | Indoor Furnishing |
| Language | English |
To Next Page
