5
WARNING
To avoid
serious injury from falling or sliding out, ALWAYS use waist restraint .
Note: Verify the stroller is locked in the open position by lifting up the rear of the stroller
using the parent’s handle .
Lock the rear brakes and pivot the child’s tray out of the way (page 6).
5-point Harness:
5-point harness, the harness shoulder straps G must start at shoulder height or
With the
shown, and use the harness strap loops H closest to the baby’s shoulders. To
lower, as
adjust the height of the harness shoulder straps to the baby’s shoulder height, do the
following:
1. Remove each harness shoulder strap G from each buckle I, as shown.
each harness shoulder strap G under the harness strap loop H that is closest to
2. Thread
the baby’s shoulder.
3. Reattach each harness shoulder strap G to each buckle I.
5-point and 3-point Harnesses:
baby in the seat and bring the crotch panel J up between the child’s legs. Fasten Place the
buckle I. For a snug, comfortable fit, pull the shoulder straps G to tighten the
each
shoulder restraint (shoulder restraint only for 5-point harness) and pull the waist restraint
straps K
to tighten the waist restraint.
loosen the waist straps K, push in the release button L on the buckle and pull .
Note: To
Once the child is properly restrained, close and lock the child’s tray. Make sure the tray
locks into position with audible clicks. Pull on the child’s tray to make sure it is locked into
place.
To change from 5-point to 3-point harness:
each harness shoulder strap G from each buckle I, as shown above.
Remove
8
9
To Next Page
Loading...
