Do you have a question about the Evenflo Reversi and is the answer not in the manual?
Reversible Seat | Yes |
---|---|
Maximum Weight Capacity | 50 lbs |
Harness Type | 5-point harness |
Brakes | Rear-wheel brakes |
Storage Basket | Yes |
Sun Canopy | Yes |
Recline | Multiple recline positions |
Parent Tray | Yes |
Child Tray | Yes |
Fold Size | 32.5" H x 25.5" W x 15.5" D |
Storage | Large storage basket |
Ensure child is supervised, always use seat belt, and prevent falls.
Adhere to weight limits for basket/cup holder and avoid prohibited uses.
Only use Evenflo SafeMax or LiteMax infant car seats with this stroller.
Always check car seat is securely latched into adapters.
Never remove toddler seat with child inside; secure child with harness.
The main structure of the stroller including the seat.
Includes front and rear wheels for the stroller.
Cup holder and car seat adapters.
Connect rear wheels to the stroller frame until they click.
Connect front wheels to the stroller frame until they click.
Squeeze frame release levers and pull up on handles.
Press down on the fold latch until it clicks and locks.
Rotate and slide cup holder onto the mount as shown.
Engage wheel lock for rough surfaces by pushing up.
Disengage wheel lock by pushing down.
Press levers DOWN on both rear wheels to lock.
Press levers UP on both rear wheels to unlock.
Press tabs towards the center of the stroller to release the seat.
Carefully pull the seat off the stroller frame.
Ensure stroller seat mounts are in the most upright position.
Squeeze handle and rotate mounts if not upright.
Stretch seat open and attach mounts to stroller frame until they click.
Pull up on seat to ensure it is securely attached before use.
Insert buckle tongues into the crotch buckle.
Push button on crotch buckle and pull tongues out.
Slide retainer to tighten shoulder and waist straps.
Push tab to loosen waist straps, slide retainer to loosen shoulder straps.
Adjust shoulder strap height by reinserting retainer into desired slots.
Fasten snaps on both sides of the canopy.
Push canopy to the front or rear of the stroller.
Pull flap out to extend the canopy further.
Squeeze handle and pull seat down into one of three positions.
Squeeze handle and pull seat up to the upright position.
Ensure seat is upright and facing forward before folding.
Lift the fold latch, squeeze handle levers, and pull frame up.
Push stroller down until it latches closed; it will stand on its own.
Press tabs towards center and pull seat off frame.
Lift the fold latch, squeeze handle levers, and pull frame up.
Push stroller down until it latches closed; it will stand on its own.
Press tabs towards center and pull seat off frame.
Insert adapters into the stroller frame mounts until they click.
Pull up on adapters to ensure they are securely latched.
Place car seat onto adapters until it clicks securely.
Lift car seat to ensure it is securely latched onto adapters.
Squeeze rear handle and pull car seat off adapters.
Wash seat pad per tag; clean frame with damp cloth and mild soap.
Check for damage and dry thoroughly if wet.
Call 1-800-233-5921 for service, warranty, or parts.
Access information and support at www.evenflo.com.