Evenflo ExerSaucer Bouncing Barnyard - Upper Leg Installation and Adjustment

4
!SSEMBLINGTHE%XER3AUCER
8. Insert three upper legs S over the springs and onto
the tray. Twist each upper leg, as shown. Make sure
height adjustment button T is facing outward.
After all three upper legs are installed, turn tray over to
the upright position.
S
S
S
T
S
S
M
9. Align and start each upper leg S into the lower leg
M. Push button T and guide upper leg into lower leg
until upper leg snaps into place.
4OADJUSTHEIGHT
ALWAYS remove baby from ExerSaucer before adjust-
ing. Push button T until the desired position is obtained.
Make sure that all three legs are adjusted to the same
position.
$URINGUSEALLOWTHEBABYSTOESONLYTOTOUCHTHEBASE
$/./4ALLOWTHEBABYTOSTANDFLATFOOTEDONTHEBASE!S
BABYGROWSANDBECOMESMOREACTIVERAISETHETRAYTOTHE
NEXTLEVELSOTHATBABYENJOYSTHEMOSTCOMFORTABLEFITAND
MAXIMUMUSEOFTHEROCKSPINANDBOUNCEFEATURES
7!2.).'
T
T