Evenflo ExerSaucer Fast Fold Go User Manual

14
15
Attaching the Toys
Press here
Remove
(Toys vary by model.)
2. Turn ExerSaucer upside down. Locate three (3) feet . Remove foot
by squeezing tabs and pulling foot off leg. Repeat until all three (3)
feet are removed.
To install toys, press firmly into tray as shown. Pull up on
stalk toys to make sure they are locked in place.
To remove stalk toys, squeeze tabs
O
and lift stalk toys
from tray.
1. Adjust legs to their lowest position.
3. Push foot
onto tray until it snaps into place. Repeat
until all three (3) feet are locked into place.
4. Locate three (3) legs
. Push release button and rotate leg down until it locks
into the lowest position. Repeat until all three (3) legs are locked into the lowest
position. Pull up on legs to make sure they are locked in place.
B
D
A
D
A
B
C
Storing the ExerSaucer
D
N
N
To adjust height:
ALWAYS remove baby from ExerSaucer before adjusting. Push
button until the unit is in the lowest position. Make sure that
all three legs are adjusted to the lowest position.
O

Evenflo ExerSaucer Fast Fold Go Specifications

General

Brand	Evenflo
Model	ExerSaucer Fast Fold Go
Category	Baby Swing
Language	English