69
Lap Belt Only (Rear-Facing and Forward-Facing)
Installing Lap Belt
10. Grab Base near belt path as
shown and pull side to side and
front to back to make sure Base is
installed tightly. Base should not
move more than 2.5 cm (1 in) side
to side or front to back at the Belt
Path on the Car Seat.
If Base moves more than 2.5 cm
(1 in), open LockStrong, tension
vehicle belt a little more, and try
again. If Base still moves too much,
you may need to try a different
vehicle seat location, installation
method, or both.
To Next Page
Loading...
